I got the Flysky version of the board because I have a Turnigy Evolution and it was incredibly easy to bind. It allows you to take an E010 or E010S frame (or probably blade inductrix frame also) and 6mm motors and go fly some acro! The board has plug ins for the motors so no excessive soldering, just the power and the camera. This flight controller is prefect if you are looking to step your tiny whoop game up to the next level. It can be corrected with transmitter calibration. There is a little assimetry of transmiiter channels and little jitter in midpoints. Succesfuly paired with FlySky FS-I6X in AFHDS 2A Mode. USB cable, power cable with connector and mounting screws with adsorbers are included in package. Package content is great but with 2 or 3 more screws it would be even better (Close to perfect).įC looks very good. (To conclude) Product is AE (As Expected).
CLEANFLIGHT FIRMWARE 1.13.0 FULL
(The different thresholds and deadbands are adjusted accordingly).Īfter the addition of connector, rubber and hot glue the design has evolved in order to keep the weight close to 20g.īecause of the PPM receiver, the drone is probably a little less powerful than the SBUS version but it works very well and with Eachine E010 1s 3.7V 200mAh 30C batteries (0 loss of altitude and full speed). (In case of PB, test/configure with a version of BTFL <= 3.5.6). The card / The drone must work correctly before putting a camera It seems like board, battery, or both dysfunction.Īpart from the fluctuation and the lack of range due to the PPM / DSM2 receiver, the aforementioned malfunctions are The drone then leaps in any direction.ī) board's excessive failsafe or reboot. One day it can display values and the next day different values.ģ - When adjusting the RANGE with the RXRANGE command, the drone behavior becomes " unpredictable ":Ī) the throttle may " takes off " suddenly. The board may behave strangely:ġ - The RANGE 1000-2000 may not be obtained.Ģ - The RANGE obtained (other than 1000-2000) fluctuates. The Betaflight version is decisive and its configuration maybe "tricky". To begin with i recommend avoiding the PPM protocol.
0 kommentar(er)
